Home
1. Leak-proof mixing shaft
1. Unscrew the spring nut (1) and take out all the springs (2) and bolts
2. Pull out the tight fixing seat (3) If the fixing seat is stuck, tap it with a nylon hammer first.
Let it loose and then turn the forcing bolt (4) out of the fixing seat
3. Tie the cloth strip with an iron rod and dip it in organic solvent, and infiltrate the solvent into the pressing and stirring shaft blades
The contact surface, remove all impurities, be sure to make the contact surface, the side wall hole and the stirring shaft clean
tidy.
2. Urgent inspection
1. Use an organic solvent to clean the pressing and mixing shaft blades on the grinding surface
2. Check whether there are scratches or unusable wear on the grinding surface of the pressing or mixing shaft blades.
3. Align the screw holes of the tightening ring and lock it on the screw holes of the bakelite fixing seat if you want to replace it with a new one
Spare two-piece compression, you need to fix each compression screw to the bakelite ring fixing seat
superior.
4. Push the fixed clamp and the bakelite fixing seat into the clamp together, requiring bakelite
flat surface.
5. Put the spring and the nut into the bolt to adjust the tightness of the 4 springs evenly, not too much
Tightening can cause damage or body friction.
Points to note:
1. When disassembling and replacing, all parts must be cleaned up, and it is required to be clean. Accumulation will also cause
Leaking powder.
2. The tightness of the four springs must be the same, and the inconsistent force of the four screws will cause powder leakage.
3. The contact surface must be flat, and there will be powder leakage if there is unevenness.
4. During 12 hours of work, you must check for powder leakage and add a small amount of lubricating oil.
To bakelite holder
5. If there is powder leakage, adjust the spring tightness according to the situation to prevent powder leakage.
6. Diligent maintenance will make the life of the machine more regular.
step 1
Step 2
Step 3
Step 4
Step 5
Step 6
